الرجاء المساعدة من جميع الاعضاء

[salah98]

عند اصلاح بوت j100h هدة قراءة الجهاز ارجو المساعدة فى طريقة اصلاح هدا الجهاز
EMMC Device Information :
EMMC CID: 65646F4D204D4F52128100000615444D
EMMC CSD: D07FFF320F59007FF6DB80001E40001D
EMMC Manufacture : , EMMC NAME: MMOR , HEX: 4D004D4F5200 , S/N: 00000615 , rev. 0x81
EMMC Manufacture ID: 0x65 , OEM ID: 0x6F , Device Type: Device (removable) , Date: 4/2017
EMMC ROM 1 (Main User Data) Capacity: 2095982 MB (01FFB6E00000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 2048 KB (000000200000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 KB (000000020000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC BootArea Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG]: 0x78 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x03
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: MMOR_00000615_20180505_133100.extcsd
EMMC Init completed.

Warning: Maybe your emmc damaged

eMMC are unusable.

[LYON]

قم بقراءة هذا الموضوع
أخيرا وبعد مئات المحاولات حل مشكلة البوت j100h و j200h وأى SPD (أرجو التثبيت) - الصفحة 1

[salah98]

عملت نفس الخطوات لكن نفس المشكلة

[NEZAR@GSM]

عند اصلاح بوت j100h هدة قراءة الجهاز ارجو المساعدة فى طريقة اصلاح هدا الجهاز
EMMC Device Information :
EMMC CID: 65646F4D204D4F52128100000615444D
EMMC CSD: D07FFF320F59007FF6DB80001E40001D
EMMC Manufacture : , EMMC NAME: MMOR , HEX: 4D004D4F5200 , S/N: 00000615 , rev. 0x81
EMMC Manufacture ID: 0x65 , OEM ID: 0x6F , Device Type: Device (removable) , Date: 4/2017
EMMC RUser Data) Capacity: 2095982 MB (01FFB6E00000)OM 1 (Main
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 2048 KB (000000200000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 KB (000000020000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC BootArea Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG]: 0x78 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x03
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: MMOR_00000615_20180505_133100.extcsd
EMMC Init completed.

Warning: Maybe your emmc damaged

eMMC are unusable.

اخي الهارد (EMCP) تالف ويجب استبداله انظر الى اسم الهارد غير صحيح وتقسيم الهارد غير صحيح وهذا هو التقسيم الصحيح

Partition:
Boot Partition 1 Capacity: 4096 KiB
Boot Partition 2 Capacity: 4096 KiB
RPMB Capacity: 4096 KiB


Partition config: 0x08
Boot from: Boot Partition 1
Boot Acknowledge : Disable


Boot bus config: 0x00
Mode Boot : Single Data Rate + Compatible
Boot Bus Width : x1 (sdr) or x4 (ddr) , width 1bit
Reset Boot Bus Width : Disable

[ahmed koukou]

تاكد من التغذيه ... او استخدم USB .

Sent from my IQ4503 Quad using Tapatalk

[mandolen]

ايه المشكله هنا

Setting frequence to 21 Mhz
CMD Pullup Level: 2000 mV
CMD Active Level: 2454 mV
EMMC Device Information :
EMMC CID: 65646F4D204D4F5212A100000240012E
EMMC CSD: D07FFF320F59007FF6DB80001E40001C
EMMC Manufacture : , EMMC NAME: MMOR , HEX: 4D004D4F5200 , S/N: 00000240 , rev. 0xA1
EMMC Manufacture ID: 0x65 , OEM ID: 0x6F , Device Type: Device (removable) , Date: 0/2014
EMMC ROM 1 (Main User Data) Capacity: 128 MB (000008000000)
EMMC ROM 2/3 (Boot Partition 1/2) Capacity: 2048 KB (000000200000)
EMMC RPMB (Replay Protected Memory Block) Capacity: 128 KB (000000020000)
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD Information :
Extended CSD rev: 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG]: 0x78 , Boot from: ROM1 (Main User Area)
Boot Bus Config: 0x00 , width 1bit
H/W Reset Function [RST_N_FUNCTION]: 0x00, RST_n signal is temporarily disabled
Supported partition features [PARTITIONING_SUPPORT]: 0x03
Device supports partitioning features
Device can have enhanced technological features in partitions and user data area
Partition Settings [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: MMOR_00000240_20190117_191132.extcsd
EMMC Init completed.

eMMC are unusable