مشكلة n9005 بعد التحديث رجاء الدخول
السلام عليكم ورحمة الله وبركاته
اجاني جهاز n9005 4.3 صاحب الجهاز اراد تحديثة الى اخر اصدار لولي بوب
المهم نزلتله فلاشه عن طريق بوكس spt وفقط ثلاث فلاشات بدون ملف الboot
الجهاز بعد السوفت علق على وضع الريكفري ولا ياخذ اي ايعاز ثم فلاشته بفلاشه كاملة اربع ملافات على الاس بي تي لكن الجهاز طفى فقط رجه ومن ثم بعد عدة دقائق يظهر الصورة المشار اليها ادناه
جربت كل ملفات ال sdc عن طريق رام دون فائدة
جربت جيتاك بالزد 3 اكس دون فائدة ارجو الحل رجاء
التقطت صور لفيرجن الجهاز قبل التفليش واخر حاله له
Z3X EasyJtag Software ver. 2.0.6.4
Loading eMMC Addon Firmware... IO: 2800 mV
Box S/N: ءءءءءءءءءءءءءءءءءءءء, ,FW Ver.: 01.52
CMD Pullup Level:1443 mV
CMD Active Level:1629 mV
eMMC Device Information
EMMC CID : 110100303332473934006090EF395F7E
EMMC CSD : D00E00320F5903FFFFFFFFEF92400044
EMMC Manufacturer ID: 0011 , OEM ID: 0100
EMMC Date: 05/2012 Rev.0x0
EMMC NAME: 032G94 , S/N: 1620111161
EMMC NAME (HEX): 30333247393400
EMMC ROM1 (Main User Data) Capacity: 29820 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
Backup saved: 032G94_1620111161_20151226_1558.extcsd
Searching for partition tables...
Detected GPT over MBR...
Medium UUID: 98101B32-BBE2-4BF2-A06E-2BB33D000C20
Warning: Entries Count = 128
MMCBLK0P0 (APNHLOS) Range: [0X400000,0X12FFE00] ,Len: F00000
MMCBLK0P1 (MODEM) Range: [0X1300000,0X4C6FE00] ,Len: 3970000
MMCBLK0P2 (SBL1) Range: [0X4C70000,0X4CEFE00] ,Len: 80000
MMCBLK0P3 (DBI) Range: [0X4CF0000,0X4CF7E00] ,Len: 8000
MMCBLK0P4 (DDR) Range: [0X4CF8000,0X4CFFE00] ,Len: 8000
MMCBLK0P5 (ABOOT) Range: [0X4D00000,0X4EFFE00] ,Len: 200000
MMCBLK0P6 (RPM) Range: [0X4F00000,0X4F7FE00] ,Len: 80000
MMCBLK0P7 (TZ) Range: [0X4F80000,0X4FFFE00] ,Len: 80000
MMCBLK0P8 (PAD) Range: [0X5000000,0X59FFE00] ,Len: A00000
MMCBLK0P9 (PARAM) Range: [0X5A00000,0X63FFE00] ,Len: A00000
MMCBLK0P10 (EFS) Range: [0X6400000,0X71FFE00] ,Len: E00000
MMCBLK0P11 (MODEMST1) Range: [0X7200000,0X74FFE00] ,Len: 300000
MMCBLK0P12 (MODEMST2) Range: [0X7500000,0X77FFE00] ,Len: 300000
MMCBLK0P13 (BOOT) Range: [0X7800000,0X82FFE00] ,Len: B00000
MMCBLK0P14 (RECOVERY) Range: [0X8300000,0X8FFFE00] ,Len: D00000
MMCBLK0P15 (FOTA) Range: [0X9000000,0X9CFFE00] ,Len: D00000
MMCBLK0P16 (BACKUP) Range: [0X9D00000,0XA3FDA00] ,Len: 6FDC00
MMCBLK0P17 (FSG) Range: [0XA3FDC00,0XA6FDA00] ,Len: 300000
MMCBLK0P18 (FSC) Range: [0XA6FDC00,0XA6FDE00] ,Len: 400
MMCBLK0P19 (SSD) Range: [0XA6FE000,0XA6FFE00] ,Len: 2000
MMCBLK0P20 (PERSIST) Range: [0XA700000,0XAEFFE00] ,Len: 800000
MMCBLK0P21 (PERSDATA) Range: [0XAF00000,0XB7FFE00] ,Len: 900000
MMCBLK0P22 (SYSTEM) Range: [0XB800000,0X9B7FFE00] ,Len: 90000000
MMCBLK0P23 (CACHE) Range: [0X9B800000,0XAE3FFE00] ,Len: 12C00000
MMCBLK0P24 (HIDDEN) Range: [0XAE400000,0XAEDFFE00] ,Len: A00000
MMCBLK0P25 (USERDATA) Range: [0XAEE00000,0X747BFBC00] ,Len: 698DFBE00
Done...Presets has been updated...
Done.
المشاركة الأصلية كتبت بواسطة alialjorany
المفضلات