ازالة حساب هواوي لHuawei P smart 2021 (PPAH-L22)

[ProfKefah]

Waiting fastboot device ...
Device found


Reading device Info ...


Device Model : PPA-LX2
Device Firmware : PPAH-L22 10.1.1.280(C185E8R3P1)
Country : MIDDLE EAST and AFRICA




Welcome to Octoplus Huawei Software v.‪1.3.5‬


To enable 'Manufacture' mode dial
- for Qualcomm and Hisilicon based models: *#*#2846579#*#*
ProjectMenu > Background Settings > USB Port Settings > Manufacture Mode
- for MTK based models: *#*#14789632#*#*
ProjectMenu > Background Settings > USB Port Settings > Debug Mode


To enable 'Fastboot' mode
1. Power off the phone. Remove SD and SIM cards
2. Press 'Vol-' and insert USB cable
3. Wait until phone enters 'Fastboot' mode


To enable 'Upgrade' mode
1. Power off the phone. Remove SD and SIM cards
2. Press and hold 'Vol-' and 'Vol+' keys and insert USB cable
3. Wait until phone enters 'Upgrade mode'


Found COM ports:
1: COM5 USB Serial Port


Job ID: 00000000018FC220
2024-08-27 17:43:18
Starting Reset Huawei ID
Selected phone model: ‪PPA-LX2‬
Warning: Please, make sure the phone`s battery is fully charged and connected, after connect the device via Factory Mode (use Hardware Test Point or "ON/OFF Factory Mode option").
Warning: Selected response: Proceed
Searching HUAWEI USB COM 1.0 port...
Detected ‪HUAWEI USB COM 1.0‬ port
Phone connect successfully
Writing bootloader KIRIN710A_V3...
Initializing remote service connection...
Downloading resource...
Writing ‪XLOADER‬ partition...
Writing ‪UCE‬ partition...
Writing ‪FASTBOOT‬ partition...
Operation in progress. Please wait for instructions...
Bootloader Update successfully
Rebooting to fastboot mode...
Warning: If you use modified USB cable please reconnect cable from the mother board and press "Ok" to proceed the operation
Warning: Selected response: Ok
Searching Fastboot devices...
Found android device: CNXNU20C25102277
Detected ‪Android Sooner Single ADB Interface‬ port
Reading basic data...
Device Model: ‪PPA-LX2‬
System: ‪PPAH-L22 10.1.1.280(C185E8R3P1)‬
Android Version: ‪10‬
Base Version: ‪PPAH-LGRP2-OVS 10.1.1.280‬
Custom Version: ‪PPAH-L22-CUST 10.1.1.8(C185)‬
Preload Version: ‪PPAH-L22-PRELOAD 10.1.1.1(C185R3)‬
C_Version: ‪C185‬
D_Version: ‪D000‬
FB Lock State: ‪LOCKED‬
User Lock State: ‪LOCKED‬
Downloading resource...
Connecting to the credit server...
Username: profkefah
Checking balance...
Your balance: 200 credits
Sending device information...
Sending firmware information...
Removing firmware protection...
Connecting to server...
Waiting for a response from the server...
FB Lock State: ‪UNLOCKED‬
User Lock State: ‪LOCKED‬
Device Model: ‪PPA-LX2‬
System: ‪PPAH-L22 10.1.1.280(C185E8R3P1)‬
MEID: ‪00000000000000‬


S/N: ‪Resetting Huawei ID...
Rebooting device...
Warning: Please perform "Clear data" manually via Recovery Mode, if your device doesn`t start properly!
Reset Huawei ID done.
Performed by ‪1.3.5‬ Software version.

[Abo Amir]

الله ينور عليك