[QUOTE=bero 2005;3331132]Z3X EasyJtag Software ver. 3.7.0.20
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 0E0020215C78ED04, ,FW Ver.: 01.63
CMD Pullup Level:1990 mV
CMD Active Level:2475 mV
Box IO Level:2800 mV
CLK Rate:21000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------
eMMC CID : 90014A483847347421016B87C00892A4
eMMC CSD : D07F01320F5903FFFFFFFFEF8A400012
eMMC Manufacturer ID: 0090 , OEM ID: 014A
eMMC Date: 09/2015 Rev.0x1
eMMC NAME: H8G4t , S/N: 1804058632
eMMC NAME (HEX): 483847347420
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC RPMB is not yet programmed (clear) or RPMB General failure
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.7 (MMC 5.0)
Boot configuration [PARTITION_CONFIG: 0x08] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x08.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H8G4t_1804058632_20230212_1643.extcsd
Partition info not found
Done.
ممكن طريقة احياء j200h على اصدار EasyJtag_Release_v3.7.0.20
المشاركة الأصلية كتبت بواسطة ali pop
ضوابط المشاركة
رد مع اقتباس
المفضلات