redmi note 6 pro frp done
Device : Xiaomi Redmi Note 6 Pro
Operation : Reset FRP
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM18)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1C00C00 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_016]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : MSM8996, EMMC, 64 GB
LU Count : 1 [0x0747C000]
Payload Info : In: 262144 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 6 Pro [tulip]
Brand : xiaomi
Prod.Name : tulip
Software : PKQ1.180904.001, V11.0.3.0.PEKMIXM [Fri jan 6 17:50:09 WIB 2021]
Android Ver. : 9
Patch Level : 2020-02-05
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 6.5
المفضلات