redmi note7 lavender miui11 frp and format done umt

**larouci** · 16-12-2019, 05:57 PM

Operation : Format FS
Checking for existing devices...Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM49)
Driver Info : HS Corporation, ghsser.sys, 10.2104.1.2
Connecting to phone...OK
Waiting for response...OK
Init Handshake Sequence...OK
Hardware ID : E1C00800 [8996] 00000000
OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21F65BA3303834E1
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Loader...Done
Sending Loader [8996_022]...Done
Executing Loader...OK
Auth Enabled Device! You need Mi Auth Account to service!
Reading Auth Blob...OK
Blob : NDE1MTQxNDE0MTQ0MzA0MjQxNDE0MzcyNTA2QTQ4NkI2RTcwMkQ3NjQ2NDEzNjM2NTIzMTcwMzA0QjZCNjk0RDU3Nzk0QjY3Njc0MT==
Requesting UMT Server for Auth Data...OK
Credits Left: 10
Authenticating...OK
Detecting Chip Type...OK
Hardware : MSM8996, eMMC, 64 GB
LU Count : 1 [0x0747C000]
Payload Info : In: 262144 [4096], Out: 131072, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi Note 7 [lavender]
Software : PKQ1.180904.001, V11.0.4.0.PFGMIXM [Sun Nov 10 06:51:30 WIB 2019]
Android Ver. : 9
Patch Level : 2019-11-05
Formatting userdata [SafeMode]...Done
Resetting FRP Lock.......Done
Operation Finished.
QcFire Ver. 5.1