معلومات التوصيل بالبوكس
============
---------- eMMC Device Information ----------
eMMC CID : 90014A48384732640485016F89809056
eMMC CSD : D02701320F5903FFFFFFFFEF8A4040D2
eMMC Manufacturer ID: 0090 , OEM ID: 014A
eMMC Date: 09/2013 Rev.0x85
eMMC NAME: H8G2d , S/N: 24086912
eMMC NAME (HEX): 483847326420
EMMC ROM1 (Main User Data) Capacity: 7400 MB
EMMC ROM2 (Boot Partition 1) Capacity: 2048 kB
EMMC ROM3 (Boot Partition 2) Capacity: 2048 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 2048 kB
EMMC RPMB is not yet programmed (clear) or RPMB General failure
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.5 (MMC 4.41)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x01
High-capacity WP group size [HC_WP_GRP_SIZE: 0x00004000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x03
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H8G2d_ 24086912_20190504_0317.extcsd
Done.
انفو كتابة ملف الدامب
==========
Checking NAND Image : C:\Users\Omar -----\Desktop\512MB.bin
Autodetected RAW data
Partition info successfully found
File successefuly loaded!
Processing file...C:\Users\Omar -----\Desktop\512MB.bin
Writing as RAW data
Z3X EasyJtag Software ver. 3.5.0.1
Skip loading eMMC Addon Firmware
CMD Pullup Level:2093 mV
CMD Active Level:2402 mV
Input file : C:\Users\Omar -----\Desktop\512MB.bin
Writing 0020000000 bytes to 0000000000... ROM1 (USER ROM)
Error writing address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Retry writing address 0x0000000000 (Attempt #1)...
Retry failed at address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Retry writing address 0x0000000000 (Attempt #2)...
Retry failed at address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Retry writing address 0x0000000000 (Attempt #3)...
Retry failed at address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Retry writing address 0x0000000000 (Attempt #4)...
Retry failed at address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Retry writing address 0x0000000000 (Attempt #5)...
Retry failed at address 0x00000000 Error Code:-8 Reason ATA SND CRC Error
Write Block Failed, Reason: DATA SND CRC Error
Done.
Done with error(s)
========
أين تكمن المشكلة
أرجو المساعدة
المفضلات