cm2محتاج فلاشة تكنوw3
لوسمحتم محتاج فلاشة ضرورى ودى معلومات الجهاز
Card found : S/N : 34B4C537 , v0137
Chinese Miracle II [MTK module] v 1.58
Operation : Check / Read Info [ v1.58 ]
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey
Wait for phone...
Phone found! [ 6 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6580
BB_CPU_NME : [MediaTek] MT6580_S00
BB_CPU_EXT : 0xCA00 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer : 0x00FF
BLVersion : 0x0001
PreLoader : Active [ Boot with PL ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x94
NAND Flash : NOT INSTALLED
eMMC Flash : 700100454838434538011AA2AFB06331
Initialize Memory ...
DRAM already initialized by Preloader
DAgent sent , init HW now
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0x70 , OEM : 0100
[eMMC] : FLASH_INF : [KINGSTON] , 8EC8H
[eMMC] : FLASH_CID : 700100454838434538011AA2AFB06331
[eMMC] : FLASH_BRT : 0x00400000 , 0x00400000 , 0x00400000
[eMMC] : FLASH_LEN : 0x00000001C8000000
[eMMC] : FLASH_UCP : 7296 MiB [eMMC 8 GiB]
DEV RID : 0x4CE2F1251A5DCAD1B73CB747475445BD
INT RAM : 0x00020000
EXT RAM : 0x40000000 [1 GiB]
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!
[AP] : Initial info read Ok!
Brand : TECNO
ProdName : TECNO-W3
ProdModel : TECNO-W3
Device : TECNO-W3
AndroidVer: 6.0
MTKxCPU : MT6580
MTKxPRJ : W3-H806-B1-M-HiOS-EG-20160705
Done!
Elapsed: 00:00:11
Reconnect Power/Cable!
رد مع اقتباس
.gif)
المفضلات