5 in 1 adapter perfect connection

**ben khalifa** · 28-03-2018, 05:47 PM

5 in 1 adapter perfect connection

Z3X Card Activation [LG] : NOT ACTIVATED
Z3X Card Activation [SAMS] : NOT ACTIVATED
Z3X Card Activation [JTAGPLUS] : NOT ACTIVATED
Z3X Card Activation [JTAG] : ACTIVATED

Config set from ****l : Vendor:LG Model:P705
Compression is ON
Selected pinout: EasyJTAG GEN1 ISP Pinout
Change EasyJTAG Pinout OK
Z3X EasyJtag Software ver. 2.9.0.0
Loading eMMC GEN1 Firmware... IO: 2800 mV
Box S/N: 01FFA00C3950E5E7, ,FW Ver.: 01.62
CMD Pullup Level:2072 mV
CMD Active Level:2629 mV
Box IO Level:2800 mV
CLK Rate:7000 kHz
Bus Width:1bit,SDR
HiPower mode is off!
---------- eMMC Device Information ----------

EMMC CID : 90014A483447326211019D76556CC168
EMMC CSD : D07F01320F5903FFFFFFFFEF8A4040DA
EMMC Manufacturer ID: 0090 , OEM ID: 014A
EMMC Date: 12/2014 Rev.0x1
EMMC NAME: H4G2b , S/N: 2641778028
EMMC NAME (HEX): 48344732622000
EMMC ROM1 (Main User Data) Capacity: 3728 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 4096 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
EMMC Password Locked: No
Extended CSD rev 1.6 (MMC 4.5)
Boot configuration [PARTITION_CONFIG: 0x08] Boot from:ROM2 (Boot Partition 1)
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x08.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00000000]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
---------------------------------------------
Backup saved: H4G2b _2641778028_20180331_2218.extcsd
Done.