مشكل في تفليش هاتف orange rise 51

[Mostafa Ms]

السلام عليكم الهاتف هو شبيه alcatel pixi 4 5045x
نوع الهاتف rise 51 5045y
جؤيت 3 فلاشات للهاتف تعطي هذا المشكل على الفلاش تول عند الوصول الى 80 في المئة


الفلاشات لا تعمل لا على cm2 ولا miracle اشستغلت فقط على الفلاش تول

[MOHAMED*GSM]

ارفع انفو الميراكل
قبل التفليش

[Mostafa Ms]

السلام عليكم الاتفو على الميراكل لا يريد اخي يعطي الانفو فقط على cm2
Wait for phone...
Phone found! [ 12 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6737
BB_CPU_NME : [MediaTek] MT6737M|MT6737_S00
BB_CPU_EXT : 0xCB00 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer : 0x0005
BLVersion : 0x00FE
PreLoader : NOT Active [ Erased ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x93
NAND Flash : NOT INSTALLED
eMMC Flash : 504E01FE35394A3158D1124B05C71C47
Initialize Memory ...
DRAM configured from IDB!
DRAM initialize passed!
DRAM size : 0x40000000
DAgent sent , init HW now
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0xFE , OEM : 014E
[eMMC] : FLASH_INF : [MICRON] , K59J1
[eMMC] : FLASH_CID : FE014E50314A39354B12D158471CA305
[eMMC] : FLASH_BRT : 0x00200000 , 0x00200000 , 0x00200000
[eMMC] : FLASH_LEN : 0x00000001D3000000
[eMMC] : FLASH_UCP : 7472 MiB [eMMC 8 GiB]
DEV RID : 0xA8E7A426DD9A702F2C594DA7509E0139
INT RAM : 0x00020000
EXT RAM : 0x40000000 [1 GiB]
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!


[AP] : Initial info read Ok!


Brand : TCL
ProdName : 5045X
ProdModel : 5045X
Device : PIXI4_5_4G
AndroidVer: 6.0
MTKxCPU : MT6735
MTKxPRJ : alps-mp-m0.mp1-V2.39.1_jhz6735m.35u.m_P50


Done!
Elapsed: 00:00:16
Reconnect Power/Cable!

[Mostafa Ms]

هذا الانفو قبل التفليش

[Mostafa Ms]

عند التفليش على cm2 يعطي هذا المشكل


======= Flash
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey


Wait for phone...
Phone found! [ 12 ]
Sync...
Inital Boot Ok!
BB_CPU_PID : 6737
BB_CPU_NME : [MediaTek] MT6737M|MT6737_S00
BB_CPU_EXT : 0xCB00 , 0x8A00 , 0x0000
Processing BROM stage
Settings for BROM configured!
SecCfgVal : 0x00000000
BromVer : 0x0005
BLVersion : 0x00FE
PreLoader : NOT Active [ Erased ]
BootLdrSS : NORMAL with PRELOADER
Processing DA stage
DA Select done, will use MTK_AllInOne_DA_v5.1624.16.07
Sending and initialize DA ...
Running DA ver.4.2 on BBID : 0x93
NAND Flash : NOT INSTALLED
eMMC Flash : 504E01FE35394A3158D1124B05C71C47
Initialize Memory ...
DRAM configured from ScatFW!
DRAM initialize passed!
DRAM size : 0x40000000
DAgent sent , init HW now
eMMC FlashIC initialized
[eMMC] : FLASH_VEN : 0xFE , OEM : 014E
[eMMC] : FLASH_INF : [MICRON] , K59J1
[eMMC] : FLASH_CID : FE014E50314A39354B12D158471CA305
[eMMC] : FLASH_BRT : 0x00200000 , 0x00200000 , 0x00200000
[eMMC] : FLASH_LEN : 0x00000001D3000000
[eMMC] : FLASH_UCP : 7472 MiB [eMMC 8 GiB]
DEV RID : 0xA8E7A426DD9A702F2C594DA7509E0139
INT RAM : 0x00020000
EXT RAM : 0x40000000 [1 GiB]
BOOT TYPE : EMMC_FLASH_BOOT
SOC VERIFY : C1
Boot Ok!


ScatCFG : BaseBand : MT6735 , Project : nck_team , Storage : EMMC
Setting : Flash Pre-Erase (Safe) : Enabled
Setting : AFF verify : Enabled
Setting : HW verify : Enabled


Switching to HSUSB
HSUSB Init Ok
BL : Check HW compatibility
BL : BBID NOT supported by BootLoader!
[BL_ERROR] : BBID : Break Flashing! This Firmware will kill phone!


Operation Failed
Elapsed: 00:00:16
Reconnect Power/Cable!

[MOHAMED*GSM]

جرب دي ملف الاسكاتر + السيستم HERE
باقي الملفات HERE
ملحوظة: لا تفلش الفلاشة كامله
فلش ملفات ثم مرر ملفات اخرى
الي ان يتم التفليش بالكامل

[Mostafa Ms]

جربت هذه الفلاشة اخي لا تعمل

[MOHAMED*GSM]

جرب مرر ملف الـ preloder
لوحده

[Mostafa Ms]

الفلاشة التي اعطيتني لا ننوفر على ملف preloder

[Mostafa Ms]

الاتفو على الميراكل
Waiting for USB Port...
Set MediaTek PreLoader USB VCOM (Android) (COM157)
Please Hold "ON" to connect with the phone...
Connected to Phone.
CPU: MT6735 SW:0000 Ver: CB00
Downloading Boot8 ...
EMMC Size: 0x01D3000000
Flash Type: EMMC
INT/EXT RAM Size: 0x0+0x0
Reading infr(EMMC)...
id:MRA58K release-keys
version:6.0
model:5045X
brand:TCL
manufacturer:TCL
PROINFO BaseAddr:0x800000 Size:0x300000
NVRAM BaseAddr:0xB00000 Size:0x500000
PROTECT1 BaseAddr:0x1000000 Size:0xA00000
PROTECT2 BaseAddr:0x1A00000 Size:0xA00000
MOBILE_INFO BaseAddr:0x2400000 Size:0x800000
SIMLOCK BaseAddr:0x2C00000 Size:0x800000
PARA BaseAddr:0x3400000 Size:0x400000
LK BaseAddr:0x3800000 Size:0x800000
BOOT BaseAddr:0x4000000 Size:0x1000000
RECOVERY BaseAddr:0x5000000 Size:0x1000000
LOGO BaseAddr:0x6000000 Size:0x800000
EXPDB BaseAddr:0x6800000 Size:0x1000000
SECCFG BaseAddr:0x7800000 Size:0x800000
OEMKEYSTORE BaseAddr:0x8000000 Size:0x200000
SECRO BaseAddr:0x8200000 Size:0x600000
KEYSTORE BaseAddr:0x8800000 Size:0x800000
TEE1 BaseAddr:0x9000000 Size:0x500000
TEE2 BaseAddr:0x9500000 Size:0xB00000
FRP BaseAddr:0xA000000 Size:0x800000
NVDATA BaseAddr:0xA800000 Size:0x2000000
METADATA BaseAddr:0xC800000 Size:0x2000000
SYSTEM BaseAddr:0xE800000 Size:0x90000000
CACHE BaseAddr:0x9E800000 Size:0x19000000
USERDATA BaseAddr:0xB7800000 Size:0x117C80000
OTP BaseAddr:0x1CF480000 Size:0x2B00000
FLASHINFO BaseAddr:0x1D1F80000 Size:0x1000000
>>Done.