UFI BOX : eMMC ToolBox released!

**ahmed mohmed 7274** · 30-12-2016, 07:54 PM

eMMC ToolBox build v291 for UFI released for public

Features in this version:

High-Speed SDIO Protocol 48MHz Max, 8bit interface for UFI
High-Speed SDIO Protocol 120Mhz Max, 8bit interface for UFI-Lite (Userarea only)
Direct eMMC (ISP) connection supported using UFI with external power source
Wide Access to eMMC partitions including boot1, boot2, userarea, RPMB, GP1,GP2,GP3 and GP4
Flexible settings, allows to set VCC, VCCQ voltage, eMMC clock and bus width auto and manually
Simple and managed raw eMMC partitions management with Read, Write, Verify, Erase and Blank Check function
Custom eMMC Partitioning supported
eMMC Userarea partition management with Read, Write and Erase function
“USERDATA” partition resize and realign
Featuring built-in Internal File System browser (Directly browse files content from raw file dump or eMMC)
Featuring “Qualcomm HS-USB QDLoader 9008” loader
Load Official files (Factory Image) directly to eMMC
Setting eMMC (Boot) Partition Config
Boot and RPMB partition size change (Samsung eMMC/MoviNAND)
eMMC Health (Samsung,Micron eMMC and MMC5.x) and Smart report (Samsung eMMC/MoviNAND)
eMMC Clear CSD “PERM_WRITE_PROTECT” bit (Samsung eMMC/MoviNAND)
eMMC re-write and restore CID (Samsung eMMC/MoviNAND)
eMMC Factory reset (Samsung eMMC/MoviNAND)
eMMC FFU/Field Firmware Update (Samsung eMMC/MoviNAND)
eMMC “Brick-Bug” recovery by TestPoint (Samsung eMMC/MoviNAND)