Screenshoot 20150815 160952 720x340


eMMC ToolBox build v291 for UFI released for public

ME MCP 0 300x188



Features in this version:

  • High-Speed SDIO Protocol 48MHz Max, 8bit interface for UFI
  • High-Speed SDIO Protocol 120Mhz Max, 8bit interface for UFI-Lite (Userarea only)
  • Direct eMMC (ISP) connection supported using UFI with external power source
  • Wide Access to eMMC partitions including boot1, boot2, userarea, RPMB, GP1,GP2,GP3 and GP4
  • Flexible settings, allows to set VCC, VCCQ voltage, eMMC clock and bus width auto and manually
  • Simple and managed raw eMMC partitions management with Read, Write, Verify, Erase and Blank Check function
  • Custom eMMC Partitioning supported
  • eMMC Userarea partition management with Read, Write and Erase function
  • “USERDATA” partition resize and realign
  • Featuring built-in Internal File System browser (Directly browse files content from raw file dump or eMMC)
  • Featuring “Qualcomm HS-USB QDLoader 9008” loader
  • Load Official files (Factory Image) directly to eMMC
  • Setting eMMC (Boot) Partition Config
  • Boot and RPMB partition size change (Samsung eMMC/MoviNAND)
  • eMMC Health (Samsung,Micron eMMC and MMC5.x) and Smart report (Samsung eMMC/MoviNAND)
  • eMMC Clear CSD “PERM_WRITE_PROTECT” bit (Samsung eMMC/MoviNAND)
  • eMMC re-write and restore CID (Samsung eMMC/MoviNAND)
  • eMMC Factory reset (Samsung eMMC/MoviNAND)
  • eMMC FFU/Field Firmware Update (Samsung eMMC/MoviNAND)
  • eMMC “Brick-Bug” recovery by TestPoint (Samsung eMMC/MoviNAND)

Download