لو سمحتم ماهو حل هذا الخطا في هذه القراءة حاولت كتابة ملف ext ولكن لم يتغير شيء
وهذه قراءة اليوم الجهاز sm-g530h
Z3X EasyJtag Software ver. 2.1.1.1
Loading eMMC Addon Firmware... IO: 2800 mV
Box S/N: =============, ,FW Ver.: 01.55
CMD Active Level:2237 mV
Box IO Level:2800 mV
CLK Rate:14000 khz
HiPower™ mode is off!
eMMC Device Information
EMMC CID : 150100514E5730304D005950BA70C12A
EMMC CSD : D02701320F5903FFF6DBFFEF8E40400C
EMMC Manufacturer ID: 0015 , OEM ID: 0100
EMMC Date: 12/2014 Rev.0x0
EMMC NAME: QNW00M , S/N: 1498462832
EMMC NAME (HEX): 514E5730304D00
EMMC ROM1 (Main User Data) Capacity: 7456 MB
EMMC ROM2 (Boot Partition 1) Capacity: 4096 kB
EMMC ROM3 (Boot Partition 2) Capacity: 4096 kB
EMMC RPMB (Replay Protected Memory Block) Capacity: 512 kB
EMMC Permanent Write Protection: No
EMMC Temporary Write Protection: No
Extended CSD rev 1.7 (MMC 5.0)
Boot configuration [PARTITION_CONFIG: 0x00] No boot partition configured.
Boot bus config [177]: 0x00 , width 1bit , Partition config [179]: 0x00.
H/W reset function [RST_N_FUNCTION]: 0x00
High-capacity W protect group size [HC_WP_GRP_SIZE: 0x00]
Partitioning Support [PARTITIONING_SUPPORT]: 0x07
Device support partitioning feature
Device can have enhanced tech.
Partitioning Setting [PARTITION_SETTING_COMPLETED]: 0x00
Backup saved: QNW00M_1498462832_20160625_1745.extcsd
Done.
المفضلات