i747 dead boot
Using EasyRepair Mode...
Checking repair data...
EasyJtag Suite ver.: 2.1.1.1 / wxWidgets 3.1.0-W-U started. Operating system ver.: Windows 7 (build 7601, Service Pack 1).
For support and updates visit EasyJtag most powerfull eMMC and JTAG tool on market. | EMMC BOX, JTAG BOX ,Z3X , BOOT REPAIR , FORENSICS TOOL
Check security...OK
Initialising: SAMSUNG SCH-I747 Config ver.:1.00
I/O Level set to : 2200 mV
Box S/N: 0EFFF0130843BCE0 ,FW Ver.: 01.55
Connecting to Target...
JTAG device: MSM8960. CPU IDCODE : 0x4F1F0F0F Mfg.: 0x787, Part: 0xf1f0, Ver.: 0x4
CPU Manufacturer: Samsung , CPU Name: ARM7GEN
JTAG device: MSM8960. CPU IDCODE : 0x706B50E1 Mfg.: 0x070, Part: 0x06b5, Ver.: 0x7
CPU Manufacturer: QUALCOMM , CPU Name: MSM8960 Rev 0.7
Halting CPU...
Initialize hardware...
Starting target communication...
Detecting emmc memory parameters of bank (0) ...
EMMC #0 : ID : 0x00000015 Name : MAG4FB Size : 14.7 G , (30777344) Blocks
EMMC #1 : ID : 0x00000015 Name : MAG4FB Size : 2.0 M , (4096) Blocks
eMMC flash device(s) found, Device ID : 0x00150000
NAND Writing GPT, PIT, MD5...
eMMC Write OK! Elapsed time: 20.899197s (195.988 KiB/s)
NAND Writing SBL1...
eMMC Write OK! Elapsed time: 1.213069s (105.517 KiB/s)
NAND Writing SBL2...
eMMC Write OK! Elapsed time: 2.115121s (121.033 KiB/s)
NAND Writing SBL3...
Packet length too large: 0xFFFFFFFF
Unknown DCC answer /PROTOCOL/
Failed writing file SBL3.BIN to eMMC flash 0 at offset 0x04070000
المفضلات