الرجاء المساعدة في تفليش هواي G610-U20 مش قابل التفليش BOOT ERROR

**mostafa shalan** · 13-02-2016, 10:02 PM

حاولت باكثر من فلاشة علي الميركال 2 وال SPFLASH ومفيش جديد ياريت اللي عندة حل يساعد ودة انفو من الميراكال
Operation : Check / Read Info [ v1.40 ]

1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 7 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6583
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0001
BB_CPU_NM : [MediaTek] MT6583|6589_S00
Processing BROM stage
SecCfgVal : 0x00000000
BromVersion : 0x05
BLVersion : 0xFE
Preloader Status : Not active (Erased)
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v5.1540.01.01
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 5300014534304D45B8532847E331B365
DA Stat : v3.2 on BBID : 0x86
DRAM not initialized , configure DRAM Settings
DRAM EmiReq Ok , 0x00B8
DRAM Init Ok , 0x00000000
DA Sent. Configure setting now ...

DA start Failed at final stage!
Check battery , cable , drivers and try try again

Boot Error!

Operation Failed
Elapsed: 00:00:02
Reconnect Power/Cable!

**rabiegsm** · 13-02-2016, 10:08 PM

جرب التبويت على خانة البوت 11

**mostafa shalan** · 13-02-2016, 10:41 PM

المشاركة الأصلية كتبت بواسطة rabiegsm

جرب التبويت على خانة البوت 11

نفس المشكلة
Operation : Flash [ v1.40 ]

======= Flash
1. Power Off Phone , Remove battery , Insert back
2. Insert USB cable. In some cases require hold BootKey

Wait for phone...
Phone found! [ 7 ]
Sync...
Inital regs read done
Boot Info :
BB_CPU_ID : 6583
BB_CPU_HW : CA01
BB_CPU_SW : 8A00
BB_CPU_SB : 0001
BB_CPU_NM : [MediaTek] MT6583|6589_S00
Processing BROM stage
SecCfgVal : 0x00000000
BromVersion : 0x05
BLVersion : 0xFE
Preloader Status : Not active (Erased)
Processing DA stage
DA Select done , sending
DA Ver : MTK_AllInOne_DA_v5.1540.01.01
NAND_ID : 00000000000000000000000000000000
eMMC_ID : 5300014534304D45B8532847E331B365
DA Stat : v3.2 on BBID : 0x86
DRAM not initialized , configure DRAM Settings
DRAM EmiReq Ok , 0x00B8
DRAM Init Ok , 0x00000000
DA Sent. Configure setting now ...

DA start Failed at final stage!
Check battery , cable , drivers and try try again

Boot Error!

Operation Failed
Elapsed: 00:00:07
Reconnect Power/Cable!

**نت كرافت** · 13-02-2016, 10:23 PM

انت حاولت تفلش الجهاز قبل كده لكن على فلاش تول او بوكس غير cm2 صح؟ لان preloader الاصلى متعدل عليه

**mostafa shalan** · 13-02-2016, 10:37 PM

دي التست من الفلاش تول هو ايسي EMMC كدة سليم ولا تالف
=============== Memory Detection Report ===============

Internal RAM:

Size = 0x00020000 (128KB)

External RAM:

Type = DRAM

Size = 0x40000000 (1024MB/8192Mb)

NAND Flash:

ERROR: NAND Flash was not detected!

EMMC :

EMMC_PART_BOOT1 Size = 0x0000000000200000(2MB)
EMMC_PART_BOOT2 Size = 0x0000000000200000(2MB)
EMMC_PART_RPMB Size = 0x0000000000200000(2MB)
EMMC_PART_GP1 Size = 0x0000000000000000(0MB)
EMMC_PART_GP2 Size = 0x0000000000000000(0MB)
EMMC_PART_GP3 Size = 0x0000000000000000(0MB)
EMMC_PART_GP4 Size = 0x0000000000000000(0MB)
EMMC_PART_USER Size = 0x00000000EC000000(3776MB)

============ RAM Test ============

Data Bus Test :
[D0][D1][D2][D3][D4][D5][D6][D7][D8][D9][D10][D11][D12][D13][D14][D15]
OK!!

Address Bus Test :
[A1][A2][A3][A4][A5][A6][A7][A8][A9][A10][A11][A12][A13][A14][A15][A16][A17][A18][A19][A20][A21][A22][A23][A24][A25][A26][A27][A28][A29]
OK!!

RAM Pattern Test :
Writing ...
0x44332211,
0xA5A5A5A5,