اخي هذا البروسيسور infomtic
لم اقم بتفليشة من قبل

من ناحية الفلاشة في موثوق منها لانها موجودة في اكثر من موقع اجنبي بنفس الموديل والبوردة

برنامج التفليش هنا
InfoTMIC_Upgrading_Tool_(IUW_v1.2)_Plus_OTG_driver

الشرح منقول للافادة


Burner uboot by OTG

1. Open iuw Burner，2. Choose "Link USB"
3. Choose " Expert burn"
4. Tick off ‘KERNAL’ , choose ‘uImage’
Tick off ‘SYSTEM’, choose ‘system.img’.
Tick off ‘USER’, choose ‘userdata.img’.
Tick off ‘ RAMDISK’, choose ‘ramdisk.img’


Using the USB to connect the tablet with Host-1 with PC（10 inch standards tablet: close to the mouth of the headset HOST-1 and 8 inch standards tablet : the HOST-1 is the port near where it start up.）
5. Make the tablet into the OTG condition, please follow the instructions as bellow:
After tablet resetting, press POWER+MENU button on the 10 inch tablet
/Press the POWER+VOICE button on the 8 inch tablet
/Press the POWER button on the 7inch tablet
6. When the little box icon turn green, press the "Burn" button on the tool. Pulling out the USB until the burning completely already, then press the RESET to restart the system.

Burner the system by OTG

Open the IUW Burner tool, choose "Link USB"
Choose"Easy burn"
Choose IUS Image file
By OTG, connect the tablet with PC (OTG ware close to Host-1)
10 inch: Press the "POWER+MENU" button
8 inch: Press the POWER+VOICE+button
7 inch: Press the POWER button
When the little box icon turn green, press the "Burn" button on the tool.
Pulling out the OTG until the burning completely already, then press the RESET to restart the system.


Burner the system by SD card

1. Open IUW Burner tool，2. choose "Boot Disk"
3. Choose ius image file
4. Get the SD card to inserting the PC with card reader
5. Choose SD card drive，6. such as“Removeable media1”
7. Press the "Burn" button on the tool
8. Insert the SD card into TF-1 port
9. Press the power button to start the burning.
7. Pulling out the SD card until the burning completely already, then press the RESET to restart the system.

ه››م€پExpert burn File instruction accordinglyï¼ڑ
· UBOOT: u-boot.img
· U0: u-boot-nand.bin
· NK: zNK.img (only use for wince，· do not choose temporarily)
· KERNEL: uImage (or uimg.xxxx)
· SYSTEM: system.img
· USER: userdata.img
· NDISK: ndisk.img (do not choose temporarily)
· RAMDISK: ramdisk.img
· RECVRD: recovery_rd.img (If it is not available, can not choose)
· SYSBACK: zSYS.img (If it is not available, can not choose)