رد: ارجو المساعدة
مثلا عندي هذا الهاتف عندما عمل خاصية ديتاكتد تعطيني
Detecting D+ and D-...
Vcc: null
Gnd: 5
Detection initiated...
D+ = 3, D- = 2
Detection D+/D- with 1,30 seconds.
Continue to detect BOOT pin...
New USB device: (VID_0E8D&PID_0003)
BOOT(Pull Up) = 1
>>Detection completed.
لكن عندما اذهب الى النوع mtk يعطيني
Detection initiated, connect the phone and power on it...
Vcc: null
Gnd: 5
Analyzing Rx and Tx...
>>Some mobile phone must have VCC or GND pins set in order to detect pinouts. Detection requires a longer period of time, please be patient...
و عند الذهاب الى master يعطيني
Available Ports:COM1 COM6
Current Port:COM6
Detection initiated...
Vcc: null
Gnd: 5
Analyzing D+ and D-...
D+ = 3, D- = 2
Detection D+/D- with 1,77 seconds.
Continue to detect BOOT pin...
New USB device: (VID_0E8D&PID_0003)
BOOT(Pull Up) = 1
Setting...
Find USB device:MTK USB Port (COM9), (VID_0E8D&PID_0003)
Pinouts setting complete!
>>If the phone ready to read and write again, please re-plug the USB or reset the pinouts.
ارجو الشرح
رد مع اقتباس
المفضلات