plus cap

Octoplus JTAG Software v.1.7.8 is out!


We have added boot repair via USB and small TP for LG D150, D157F, D160, D160F, D160G,
which are detected by PC as "Qualcomm HS-USB QDloader 9008" device!


Also added repair via JTAG interface for Samsung SGH-T479B and ZTE V880G.


Octoplus Box JTAG Software v.1.7.8 Release Notes


Added support for the following models:


- LG D150 - added Dead Boot/Device Repair via USB
- LG D157F - added Dead Boot Repair via USB
- LG D160 - added Dead Boot/Device Repair via USB
- LG D160F - added Dead Boot Repair via USB
- LG D160G - added Dead Boot Repair via USB
- Samsung SGH-T479B - added Dead Boot/Device Repair
- ZTE V880G - added Dead Boot Repair (thanks to Mr. Dr_Wolodya)
All pinouts and Repair procedures are described in the manual ("Help" button in Software).




To repair mentioned above devices via USB, please follow the next three steps:
Attach testpoint as shown on Figure 1 in the Software manual and connect your phone using Micro USB cable directly into the mainboard’s USB port
(do NOT use any USB hubs!)
Check PC Device Manager, a new device should appear "Qualcomm HS-USB QDLoader 9008" or "Unknown Device" if you hadn’t installed the driver yet.
Drivers are in {Installation_Folder}\Driver\QHSUSB
Release testpoint and press “EasyRepair” button in the software (or “Connect” button, when in Advanced Mode)





Download Octoplus Box JTAG Software v.1.7.8
Find out more at: Octoplus Box - flashing, software repair and unlocking of LG, Samsung, Sony Ericsson and other devices