6500sممكن مساعدة كنتكت سرفس بعد التفليش على الhwk

[yasar18]

السلام عليكم بعد التفتيش 00.v10يعطى كنتكت سرفس وهاده الانفو

MCU SW : V 10.00 06-03-09 RM-240 (c) Nokia
PPM SW : V 10.00 06-03-09 RM-240 (c) Nokia M10
Product : Nokia 6500s-1
Prd.Code: 0556236
Bpr.Code: 0543753
Prod.Sn : CTF270202
HW Vers : 1000
EM VILMA: 15
EM BETTY: 22
RFIC Ver: 17141715
DSP Vers: ICPR71_09w03
LCD Type: SHARP
IMEI : 353077-02-364987-5
SL Serv : SIMLOCK SERVER
SL Conf : 244-07-00000000000
SL Prof : 0000000000000000
SL Count: 00 00
BLK1= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK2= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK3= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK4= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK5= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK6= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
BLK7= L1: OPEN L2: OPEN L3: OPEN L4: OPEN L5: OPEN
Provider: Nokia Test;Finland

[hassan moamen]

لوو معاك تربو او ميكس ارفع اسكان لو سمحت لان التورنيدو مش هيوضح كل المناطق

[yasar18]

شكرا على المتابعة -لا هملك البوكسات المدكورة لاكن لديا الامتى والبست

[seakrokram]

ارفع الانفو على البيست

[yasar18]

card found: A1B5CCE8
registered to: CycloneBox

Connect phone on selected interface...

UFS S/N 94017 boot - Ok

Connect phone on selected interface...

Read and Check phone data...
BB5 bus checking...
Setting FlashMode
FlashMode set Ok
No answer from phone...
- > 1. Check cable/connection, try again
- > 2. Maybe HW fault or bad cable

Read and Check phone data...
BB5 bus checking...
Setting FlashMode
FlashMode set Ok
No answer from phone...
- > 1. Check cable/connection, try again
- > 2. Maybe HW fault or bad cable

Read and Check phone data...
BB5 bus checking...
Setting FlashMode
FlashMode set Ok

1st boot Ok, C0

CMT part info :
CMT ASICID : 000000010000022600010006010C192101003000
CMT EM0 ID : 00000295
CMT EM1 ID : 00000B22
CMT PUB ID : 10400202D8990254EF289F2E071DF29150225554
CMT MODE ID : 00
CMT R_HASH : BAF3A9C3DBFA8454937DB77F2B8852B1
CMT ROM ID : 273F6D55DFAAF68F

CMT : Sending 2nd loader...
Use : RAP3Gv3_2nd.fg , Rev : 0.0 Ver : 10.42.0
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 003F0001 , CMT , NOR
CMT Flash ID : 003F0001 < SPANSION => 72NS512P
FLCNT : 00000000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAP3Gv3_algo.fg , Rev : 0.0 Ver : 10.40.0
CMT Algo sent
CMT PAPUB : A69838E8C5F20150E64E2E6E06DE6E50B26B593F32
Transmission mode : Dual (Ddr, TX2)

Boot Done!

PrReq : NOR , 00

Init Service mode... Wait...

SDD Key status : SDData is Ok
CMLA Key status : CMLA key Not exist
SimLock status : SimLock is Ok

Security status : Security Damaged!!!!!
- > Do Local SX4 or Server SX4 , Upload Tune ( checkbox or manual )

-----------------------

PA_SimLock Version :
PA_SL2 phone detected


Done!

Connect phone on selected interface...

Phone found!
Series 40 Device detected!
read info... - Ok

Reading Phone Info....
Connected phone - Nokia 6500s-1
Software ver : V 10.00 06-03-09 RM-240 (c) Nokia
IMEI : 353077023649875
DSP Ver : ICPR71_09w03
PPM : V 10.00
06-03-09
RM-240
(c) Nokia
M10
CNT : Content: m10
V 10.00
06-03-09
RM-240
(c) Nokia

Product SN : CTF270202
Product code : 0556236
Base Prd.code: 0543753
Module code : 0203327
Long Prod.SN : 0
Hardware info=======
HWID : 1000
Retu : 15
Tahvo : 22
Batery: 4549 mV
CMT BT: Error
APE BT: 2222-143
APE HW: Error
LCDVer: Error
RF ic : 17141715
Lock info ===========
IMEI : 353077023649875
IMEI spNet :
IMEI svNet :

Conf key : 0000000000000000
Provider key : 2440700000000000
Country : Finland
Operator : NOKIA (Open)
Counters : Key 0 [3] , Fbus 0 [10]
Blocks : 7

LOCK STATUS :
=============================
BLK : 1
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 2
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 3
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 4
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 5
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 6
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
BLK : 7
Lock1:Open Lock2:Open Lock3:Open Lock4:Open Lock5:Open
=============================
LOCKS : All Open
=============================
User Code : not set
MMC pwd : no any record found
UserDataExLevel : Full [PhoneBook, Calendar, PWD, SMS, Gallery]

Done!

[seakrokram]

الجهاز مضروب سكيورتي
على البيست من قائمة Repair اشر على Use Custom Key ثم اضغط على
Local SX4 Auth
وارفع اللوغ والسكان

[yasar18]

الشكر الجزيل على الاهتمام بالموضع. Phone found!
Series 40 Device detected!
read info... - Ok

Local SX4 procedure started...

Check SD : Key is Ok
Phone Imei: 353077023649875
Use custom key...
Step 1...
Step 2...
Step 3...
SX4 Auth - Ok
Upload PM checked
Uploading RF/Battery tune to phone...
Using : RM-240.pm
Operating mode is OK, no need change...


Check ST_SECURITY now...
Security status : ST_SECURITY => OK

Done!

Elapsed: 00:00:03

Upload done

بعد القيام ب Local SX4 Auth

[yasar18]

جزاك لله خيرا العملية تمت بنجاح و الهاتف شغال والحمد لله

[seakrokram]

الف الف مبروك يابوب

[Mahmoud fosh]

متابعة اكثر من رائعة