Read and Check phone data...
BB5 bus checking...
Setting FlashMode
FlashMode set Ok
1st boot Ok, C0
APE part info :
APE ASICID : 24200705
APE MODE ID : 00
APE PUB ID : 1BA7B90AD12A22AD547AF01F6476938DB32BE5C7
APE R_HASH : BA8710A7E1CD5A2909B9A875DB27AA24
CMT part info :
CMT ASICID : 000000010000022600010006400C192101021103
CMT EM0 ID : 00000295
CMT EM1 ID : 00000B22
CMT PUB ID : 0AE0010235A600583535E352DC82F08954A3A1D1
CMT MODE ID : 00
CMT R_HASH : CAEEBB65D3C48E6DC73B49DC5063A2EE
CMT ROM ID : A8C1D6713E691FF8
CMT : Sending 2nd loader...
Use : RAPIDOv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00350001 , CMT , NOR
CMT Flash ID : 00350001 < SPANSION => 72NS128N
FLCNT : 00000000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPIDOv11_algo.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
CMT PAPUB : 25129A39D9A3B031CA0124E1E90F5A17ED3EFC896F
Transmission mode : Dual (Ddr, TX2)
APE : Sending 2nd loader...
Use : omap2420_m1_2nd.fg , Rev : 0.0 Ver : 1.39.0
APE Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 004000EC , APE ,
APE Flash ID : 004000EC < SAMSUNG [SEC] => KAT00F00RA [NAND]
ReqAlgo : APE , OMAP2420 UNISTORE-II-1.5.1 ALG
FLASHID : 0000FFFF , APE , MMC , EXT
APE Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : teflon_sam_nand_xsr151_m1.fg , Rev : 0.0 Ver : 1.52.0
APE Algo sent
APE PAPUB : 25129A39D9A3B031CA0124E1E90F5A17ED3EFC896E
Transmission mode : Dual (Ddr, TX2)
Boot Done!
PrReq : NOR , 00
PrReq : NAND , 010300000000000000000000000000
Init Service mode... Wait...
Init Service Mode Failed, can't proceed checking...
Connect phone on selected interface...
Series 40 Device detected!
read info... - Ok
Phone disconected!
Connect phone on selected interface...
NOKIA N95 RM-159
seakrokram شَكر
.gif)
رد مع اقتباس
المفضلات