Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.37, JTAG Manager Version: 1.56
Selected Resurrector: [Samsung I9100P V1.0.4800.6208]
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 2.79V, TCK Frequency is 8 MHz
Settings Code: 0x22020B00000000000000000000008000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...OK
Starting communication with resurrector...OK
WARNING: DCC Loader was unable to initialize FLASH1 chip. Error code: 0x00000048
Looking for the RIFF BOX DCCLoader USB Interface Port...FAILED
The DCCLoader USB Interface is not found. Communication continues over the DCC Interface
ERROR: Selected FLASH2 Chip was not Recognized by the DCC Loader. Terminating.
السلام عليكم بارك الله فيكم ايها الفرسان انا لم تنجح معي العملية بالرغم من اعادة المحاولات
المفضلات