n900 look code رمز حماية
n900 look code رمز حماية
فلشتة مرتين على التربو مشعايز
يلغى الرمز وعلى الميمو بيجيب
OPTIONS
-F, --fiasco=ARG ******** of a FIASCO image
-k, --kernel=ARG ******** of kernel image
-n, --initfs=ARG ******** of initfs image
-r, --rootfs=ARG ******** of root JFFS2 image
--cmt-2nd=ARG ******** of CMT FIASCO 2nd image
--cmt-algo=ARG ******** of CMT FIASCO algorithm image
--cmt-mcusw=ARG ******** of CMT FIASCO MCUSW image
--cmt-no-verify Disable verification of CMT programming
-x, --xloader=ARG ******** of X-Loader image
-s, --secondary=ARG ******** of NOLO secondary bootloader image
-2, --2nd=ARG ******** of NOLO cold flasher ("2nd") image
-u, --unpack[=ARG] Unpack a FIASCO image
-f, --flash Load and flash all supplied images
-l, --load Only load all supplied images
-b, --boot[=ARG] Boot the kernel with optional cmdline
-R, --reboot Reboot the board (e.g. after flashing NOLO)
-i, --read-device-id Print out the device type
-S, --serial-port=ARG Serial port used for cold flashing or "usb"
-I, --init-port Only initialize the serial port
-c, --cold-flash "Cold flash" the device
-h, --hw-revision=ARG Specify product code and HW revision
--enable-rd-mode Enable R&D mode on the device
--disable-rd-mode Disable R&D mode on the device
--set-rd-flags[=ARG] Set R&D mode flags on the device
--clear-rd-flags[=ARG] Clear R&D mode flags on the device
--query-rd-mode Query the device R&D mode status and flags
--set-hw-revision[=ARG] Set HW revision override on device
--flash-only=ARG Flash only certain components
-U, --usb-device=ARG Specify USB device to use (bus:device address)
وعلى برنامج الاوامر الجاهزة كلمة accept
مش بتظهر خااالص
مشعارف اعمل اية
رد مع اقتباس
المفضلات