السلام عليكم
نوكيا 1280 بعد الفلاش بل mxbox
لم يشتغل

MXKEY [OMNIKEY AG Smart Card Reader USB 0], SN: xxxxxxxx
Using device: HTI, FW ver: 00.50, SN: xxxxxxxxx
Connection status: OHCI:HUB:USB 2.00 (Full-speed)
Driver: WinUSB, ver: 3.5.0.0
Module ver: 1.0.0.19663(13-12-2011), Library ver: 1.0.0.13682(17-12-2011)
Do not disconnect or abort this operation otherwise phone will be damaged.
Device synchronized.
CPU: XGOLD 110
Using embedded SBL from MCU.
Sending EBL Loader ...OK
Sending EBL ...OK
Getting EBL Version ...
Boot mode: 0xCC
EBL version major/minor: 10.19
EBL version : Default_RAM_Bootloader
Set baud rate to: 921.60 Kbit/s
Flash ID: 0020 88C0 [ST M58MWR064FU,64 Mbits]
Processing file: rm647_006.510
Downloading item CODE:hw_b2_rm647_r06.510.fls, num block: 3, size: 4.04 MB
Erasing area 0x00800000-0x00A0FFFE ...OK
Programming completed in 50.187 s
Erasing area 0x00C60000-0x00E5933E ...OK
Programming completed in 47.547 s
Erasing area 0x00FFC000-0x00FFC03E ...OK
Programming completed in 0.156 s
Error reading checksum!
Processing file: rm647_006.51ic
Downloading item CUST:hw_b2_rm647_006.51ic.fls, num block: 1, size: 1.25 MB
Erasing area 0x00210000-0x0034EABE ...OK
Programming completed in 24.406 s
Checksum mismatch: Phone calculated 0x0035, software calculated 0x3F45
Total time for flashing process(boot+erase+write) was 3 min 16.859 s