بسم الله الرحمن الرحيم
ممكن حد يعرفان الرسل ده كل ماجى اعمل سوفت نوكيا
Getting MCU ID
Phone didn't answer with TX line high after UEM reset!
Causes:
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.
MCU ID: 0xCCCC
Failed! Aborting!
Done!
Phone Restarted...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Checking path: C:\Program Files\Nokia\Phoenix\Products\RM-340\
Searching for default ******** of ini...
Checking path: \Products\RM-340\
Searching for JAF saved ******** of ini...
Checking path: C:\Program Files\Nokia\Phoenix\Products\RM-340\
No ini files found...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.mcusw
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.mcusw
PPM Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.ppm_ic
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.mcusw
PPM Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.ppm_ic
CNT Flash file: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.image_ic
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Backing up PM Field 208 as RPL...
Setting local mode...
Failed! Aborting!
Failed to backup imei...
MCU: C:\********s and Settings\M.S.H\Desktop\rm340__07.60.mcusw
Booting phone...
Phone didn't answer with TX line high after UEM reset!
Causes:
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.
MCU ID: 0xCCCC
This MCU ID is not supported in chosen flash file...
Error booting phone...
المفضلات