MicroWire support over Martech CLIP !
Next protocol is supported, from now you can have MicroWire read/write/verify over you CLIP device :-)
How it works ? It's simply, you are making wires and the rest process is executed on CLIP, totally without PC.
Both modes are possible: with desoldered microwire memory, or in circuit (in board programming).
Supported:
- 93C06 (256b Serial MicroWire bus EEPROM)
- 93C13 (256b Serial MicroWire bus EEPROM)
- 93C14 (1Kb Serial MicroWire bus EEPROM)
- 93C46 (1Kb Serial MicroWire bus EEPROM)
- 93C56 (2Kb Serial MicroWire bus EEPROM)
- 93C66 (4Kb Serial MicroWire bus EEPROM)
- 93C76 (8Kb Serial MicroWire bus EEPROM)
- 93C86 (16Kb Serial MicroWire bus EEPROM)
You must have RCD or RCD PRO activated to run this tool.
Download it:
MicroWire Tools v10
User manual (diagrams, connections, photos, how to upload):
MicroWire Tools Manual English
You can also use public support, here you can find datasheets for memories too:
(CLIP folder)
This is not the end of new protocols in support
Best regards
Martech Team
martech.pl :: Forum index
المفضلات