M700
Hold the Power button and press the Reset button using the stylus. Release both buttons at the same time and
next press the 'End Button' until the inquiry screen appears. Reply to the question.
x500+
If the touch screen is functional then tap Programs> Utilities and than Default Setting.
Otherwise Hold the “Power Button” and press the “Reset Button” with the stylus, and release both buttons
simultaneously. Next, hold the End Button until the system inquiry screen is displayed, then release the End Button
and answer the question(s) to perform a clean boot (Hard Reset).
x800
To perform a Clean Boot(Hard Reset) hold the “Power Button” and press once on the “Reset Button” with the
tip of the stylus, and release both buttons simultaneously. Next, continually hold the End Button until the
system inquiry screen is displayed, then release the End Button. Answer the question(s).

FUJITSU-SIEMENS /-
Loox 400 series
Simultaneously press reset button at the bottom using stylus cap and the Suspend/Resume button on top front
of the unit. After about 10 seconds a pictures will appear on th screen and a tone sounds
Loox 720 - 710
Use the point into the unscrewed stylus cap to press the soft reset button at the bottom and at the same time
press the button suspend/resume in front right corner. After about 10 seconds, when you will see a new screen
image and you will hear an advice sound, follows the relative instruction.
Loox n500/520
Take the stylus and screw it apart.
Press the tip into the soft reset opening and at the same time the suspend/resume and calendar buttons
Hold the suspend/resume and the calendar button pressed for a few seconds. The reset can take a few minutes.
A signal is sounded after the reset is complete. Follow the instructions
T830/T810
Slide off the battery cover and quickly remove an then refit main battery. Wait few seconds and athe same time
press the End button and the Reset button using the stylus tip. The screen will show some options.
Select SKIP to perform a normal cold start, or Factory Defaults if you confirm to performe an Hard Reset.
When a signal will sound follow the instructions on the screen