iPaq 3600, 3700 Series
bottom
Press the recessed soft reset button in the hole on the bottom right for more than 3 seconds to perform a hard reset.
You can also perform a hard reset opening the door on the bottom left of the device and moving the switch behind
the door to obtain the same result
iPAQ H3800/H3900/5450/5500
To perform a hard reset first remove the expansion packs if any, thence turn the device on (not connected to AC
power) and press
hold two outside buttons ( 1 Calendar and 4 iPAQ Task ), also insert stylus into
the reset button at bottom of iPAQ and pressing and holding this for 5 secs. Release the above buttons in any
sequence. To reactivate iPAQ, insert stylus into soft reset button or simply connect iPaq to AC adapter.

DELL /-
Axim x5/ X3i
Another procedure a little more involved than the others.Press and hold the Power Button thence, using the stylus
press and hold the reset button on the left side of the unit until the message "To clear all data press the Contacts
button" is shown.
Press the required button located to the left of the directional pad. When you see the message "Tap the screen to
set up your Pocket PC" execute the requested action and follow the instructions on screen to set up your PDA again
Axim X30 / X50
To perform an hard reset press and hold the Power button and at the same time the Reset button by the stylus
for about 2 seconds. Follow the instructions shown.
Axim X51
To perform an hard reset press and hold the Power button and at the same time the Reset button by the stylus
Release the 2 buttons and you will see on the screen the instructions To clear all data in the memory
Press Contacts button to complete the hard reset. Otherwise press Mail button to cancel the operation.

ETEN /-(glofiish)
m500
Press and hold the power button and at the same time press, using the stylus, the Reset button on the device's side.
M600 - G500
Press and hold the power button and at the same time press,using the stylus, the Reset button on the device's side.
Release both buttons at the same time and reply YES to the questions to cancel registry and to reinstall default
settings.
X500
Hold the “Power Button” and press the “Reset Button” with the stylus, and release both buttons simultaneously.
Next, hold the End Button until the system inquiry screen is displayed, then release the End Button and answer the
question