Argon: K1s, K3, V1100, V3re (V3 EDGE, V3_06), V3re (boot v. 0C.F4), V3xx, V3xx Cingular (North America), V6maxx,
V9, Foma M702iG, Foma M702iS.
LTE2_ROM4: L9, L72, U3, W5, W490, W510
- Connect powered ON handset to PC via Smart-Clip (phone > USB cable > Smart-Clip > LPT cable > PC).
- Connect S-Card to PC USB port.
- Connect power supply to Smart-Clip and power on the handset.
- Launch SmartMoto.
- Choose "Smart-Clip USB port" in phone connection window.
- Press "Search". The software should perform the following steps:
- SmartMoto detects S-Card;
- SmartMoto detects Smart-Clip;
- SmartMoto detects the handset and reads all phone information.
- Log to bookmark "Prepare"
- Select an appropriate model from the list.
- Mark "Unlock automatically" and press "Prepare Smart TestPoint" button.
- Prepare operation is in progress. The handset gets reloaded, backup of firmware is saved.
- SmartMoto pops up the message requiring Smart TestPoint cable to be connected. Please perform the following:
- Disconnect the handset and dismantle it
- Please ensure that LCD is disconnected from the board!!!
- Connect Smart TestPoint cable to the port RJ45 on Smart-Clip
- Connect data cable to the phone
- Connect battery hook to the positive (+) battery contact on PCB
- Connect needle A to the primary TestPoint A, hold it until the software informs that it can be disconnected and press OK in SmartMoto.
- The handset should be detected with boot version 0.00.
- Unlock procedure continues.
- Disconnect TP needle when SmartMoto informs to do so.
- If the option "Unlock automatically" was marked – the handset becomes unlocked. If the option was not selected then the handset can be served for Flash, Repair PDS, Unlock or Backup purposes.
NOTE. W490/W510 and Foma M702iG schematic contains 2 TestPoints, A (primary) and B (secondary). In case if unlock fails using single TestPoint A, please perform the process, using both TestPoints simultaneously (connect needle A to TP A and needle B to TP B).
The
Smart TestPoint v2.0 cable contains two TestPoint needles and a Battery Hook:
- Yellow - TestPoint A (Primary)
- Black - TestPoint B (Secondary)
- Red - Battery Hook
Please follow this order strictly. Do not use power from the battery. Use battery hook and ensure that it’s connected to the appropriate ("+" Positive) contact.
المفضلات