ممكن مساعده فى سامسونغ GT-E2652W
عند تفليش جهازه سامسونغ e2652w ب FlashTool_E2_ROU
ينقطع التفليش ويظهر في النافدة مايلي ارجو المساعدة :
Device synchronized.Injecting EBL-Loader (RPSI).
Injecting EBL
Boot-loader is active
EBL version: 6180_Bootloader_10.0_MKEYSKEY 10..0
Boot mode is: BB
Using: Faster CRC, Writing all blocks
Package length is 16384 - protocol: 3.32
Baud rate set to 921600
Get flash id.
CFI stage 1
Flash ID is: 220800EC
CFI stage 2
Boot process finished
Start downloading item 'BOOT CORE SLB:dwdtoolsrc/bootcore/make/.output/XMM6180_EHS2AGR_CATFISH_ROU_TETHYS/fls/psi_flash.fls'' from file 'C:\flash e2652w\E2652WJPKF1_psi_flash.fls''.
Erasing all flash memory
Sending sec-pack.
Load region 0
Use flash pre-erase.
Sending data.
Sending end-pack.
Checksum OK (0x8005)
Verify OK
Process time was 6.1 sec.
Start downloading item 'CODE:../HW/XMM6180_EHS2AGR_CATFISH_TETHYS_WIFI_1.0_jp/BSY_DEBUG/CATFISH.fls'' from file 'C:\flash e2652w\E2652WJPKF1_BIN.fls''.
Sending sec-pack.
Load region 0
Use flash pre-erase.
Sending data.
Process time was 2 min 10 sec.
Stopped at 31% total, 15% current
Timeout occured during packet reception
The phone did not answer within the timeout period. This could be that the communication is interrupted or that the target SW is in an endless loop.
Check the connection to the phone, battery etc. If the problem persists report the error to the developer.
Channel 1 is succesfully closed.
رد مع اقتباس
المفضلات