مشكله فى تفليش 1200

[king_star_888]

السلام عليكم ورحمه الله

معى جهاز 1200 فاصل باور بنزله سوفت مش بيكمل

ودى القراءة


Getting MCU ID
MCU ID: 0x2292
FLASH ID0: 88280020 <=> ST -> Type not in database Addr0: 0x01000000 - 0x01FFFFFF, SectorSize0: 10
FLASH ID1: 00010000 <=> Flash -> not used Addr1: 0x02000000 - 0x02FFFFFF, SectorSize1: 0
First 16 bytes: AD 7E B6 1A 1B BE 0B E2 7D 58 6B E4 DB EE 65 14
Checking RAM for ALGO...
Algo is ready...
Checking FAID calculation...
P-key nokia module version 01.02
Done!
Phone Restarted...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Checking path: C:\Program Files\Nokia\Phoenix\Products\RH-99\
Searching for default ******** of ini...
Checking path: \Products\RH-99\
Searching for JAF saved ******** of ini...
Checking path: C:\Program Files\Nokia\Phoenix\Products\RH-99\
Scanning ini files...
Checking path: \Products\RH-99\
Checking path: C:\Program Files\Nokia\Phoenix\Products\RH-99\
FILES SET FOR FLASHING:
MCU Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh99_05.910
PPM Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh99_05.91if
CNT Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh990_nai5.91if
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Changing flashing settings...
Checking path: \Products\RH-99\
Checking path: C:\Program Files\Nokia\Phoenix\Products\RH-99\
FILES SET FOR FLASHING:
MCU Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh99_05.910
PPM Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh99_05.91ic
CNT Flash file: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh990_nai5.91ic
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Languages in ppm: English,Arabic,French,Swahili
Backing up PM Field 208 as RPL...
Setting local mode...
Failed! Aborting!
Failed to backup imei...
MCU: C:\Program Files\Nokia\Phoenix\Products\RH-99\rh99_05.910
Booting phone...
Phone didn't answer with TX line high after UEM reset!
Causes:
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.
MCU ID: 0xCCCC
This MCU ID is not supported in chosen flash file...
Error booting phone...

[AhMEd TOhAMY]

شيل العلامه اللى امام rpl 208
واعد عمليه التفليش