6230i يقفل لما تدخل على النغمات حاولت افلشه او اضبطه مصنع فيعطى هذه الرساله على التورنيدو
والان فصل تفتحه يعطى شاشه بيضه بس
1st Boot Err: Bad Resp UPP, 02 FF FF 72
1st Boot Ok, 1
1st Boot Err: 00 00
Rebooting Mobile
وعلى الجاف
Getting MCU ID
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.
MCU ID: 0xDDDD
Failed! Aborting!
Done!
Phone Restarted...
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Switching to serial...
Powering the phone...
Reading...
Failed! Aborting! IMEI
Changing mode...
Done!
FILES SET FOR FLASHING:
MCU Flash file: NONE
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.880
PPM Flash file: NONE
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.880
PPM Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.30g
CNT Flash file: NONE
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Languages in ppm: English,French,German,Spanish,Arabic
Phone Type:
FILES SET FOR FLASHING:
MCU Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.880
PPM Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.30g
CNT Flash file: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.30.ucp_g
ADSP Flash file: NONE
APE Variant file: NONE
APE User Flash file: NONE
Languages in ppm: English,French,German,Spanish,Arabic
Backing up PM Field 208 as RPL...
Setting local mode...
Reading IMEI...
Failed! Aborting!
Failed to backup imei...
MCU: C:\Program Files\Nokia\Phoenix\Products\rm-72\rm72_73_11003.880
Booting phone...
FAILED ->jaf configuration 2
FAILED ->jaf configuration 1
Phone didn't answer with TX line low after UEM reset!
Causes:
1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
2. UEM damaged -> replace uem.
MCU ID: 0xDDDD
This MCU ID is not supported in chosen flash file...
Error booting phone...
المفضلات